Velcro 30" Long Installation Strip
Works with Models: DustChek Pre-Cut Vent Filters, VentGuard Vent Filtration Kit
30" Velcro Installation Strip is used in conjunction with the VentGuard Vent Filtration Kit or DustChek Pre-Cut Vent Filters to install the filter media over incoming air supply vents (registers) in your home. The purpose of either of these vent filters is to capture dust, allergens, and other airborne particles circulating through a central system's ductwork before these particles can enter a room through the vent register.
Easy to install, one side of the Velcro strip is affixed to the VentGuard "cut-to-fit" filter or the DustChek 7x11" pre-cut filter. The other side of the Velcro strip is affixed to the perimeter of the front panel of your vent grille (see Instructions tab for details). The Velcro Installation Strip adheres to most surfaces, including fabric, metal and plastic. Package contains one (1) 30" Velcro Installation Strip.
Installation Instructions ‐ DustChek "Pre-Cut" Vent Filter:
Each of the pre-cut DustChek vent filters in the package measure 7x11". These can be used as is, or if your vent register is smaller, you may prefer to trim the filter to fit.
- To install, simply trim the DustChek filter media to the size of the incoming air supply vent (register) that you wish to cover.
- Cut the Velcro (30" strip included with DustChek) to a size that will fit around the perimeter of the vent register.
- Remove the adhesive backing from one side of the Velcro strip and attach to the filter media.
- Remove adhesive backing from the other side of the Velcro strip and attach the assembled filter to the perimeter of the vent register.
- We recommend that you only cover a few vents in your home with a vent filter, so as not to strain your forced air system.
- If mold is a concern, you may want to consider treating the DustChek filter with our filter spray by Goodmorning, which will neutralize any mold spores that may pass through the filter media.
Installation Instructions ‐ VentGuard "Cut-to-Fit" Vent Filter:
- To install, simply cut the VentGuard filter media to the size of the incoming air supply vent (register) that you wish to cover.
- Cut the Velcro (30" strip included with VentGuard) to a size that will fit around the perimeter of the vent register.
- Remove the adhesive backing from one side of the Velcro strip and attach to the filter media.
- Remove adhesive backing from the other side of the Velcro strip and attach the assembled filter to the perimeter of the vent register.
- We recommend that you only cover a few vents in your home with a vent filter, so as not to strain your forced air system.
- If mold is a concern, you may want to consider treating the VentGuard filter with our filter spray by Goodmorning, which will neutralize any mold spores that may pass through the filter media.